Avtech RMA-PS1-SEN Installation - Page 2

Parcourez en ligne ou téléchargez le pdf Installation pour {nom_de_la_catégorie} Avtech RMA-PS1-SEN. Avtech RMA-PS1-SEN 3 pages. Power sensor

Power Sensor (RMA-PS1-SEN)

Step 3: Connect your Power Sensor to Room Alert.

Do not connect the dry contacts on AVTECH products or other electrical appliances

to live circuits.

Use only low-voltage 2-wire cable to connect dry contacts.

Step 4: Connect your Power Sensor to the power source you wish to monitor.

1. Connect the power adapter to the power port

on the Power Sensor.

2. Insert the power adapter plug into the power

supply you wish to monitor. Notice that the

sensor's LED lights up when your power

source is on.

Use only AVTECH's 5V International Power Adapter. Others could damage the

sensor.

Configure Your Power Sensor

Using Room Alert's Web Interface

SettingsSensors

Navigate to

below will vary depending on your Room Alert model.

AVTECH Software, Inc.

1. Run the speaker cable from the Power Sensor back to your Room

Alert monitor or Wireless Sensor Hub.

2. Connect the free ends of the speaker cable to an open switch

sensor port on your Room Alert monitor or Wireless Sensor Hub.

Again, the Power Sensor's contacts are non-polarized, so you may

connect either lead to either side of the open port.

in your Room Alert web interface. The options you see

Page 2 of 3

AVTECH.com