Avtech RMA-PS1-SEN Installation

Parcourez en ligne ou téléchargez le pdf Installation pour {nom_de_la_catégorie} Avtech RMA-PS1-SEN. Avtech RMA-PS1-SEN 3 pages. Power sensor

AVTECH's Power Sensor monitors the on/off state of a power

source, such as main power, a UPS, surge protector or

standard wall outlet. Simply plug the Power Sensor into the

source you wish to monitor. When the power goes out, it sends

a signal to Room Alert. Install multiple Power Sensors to

generate alerts when one source fails and the back up takes

ove r.

Power Sensor Package Contents

 One (1) Power Sensor ID box

 One (1) 25' speaker cable

 One (1) AVTECH power adapter

 One (1) Installation Note (You're reading it now.)

The Power Sensor ID Box

Power

LED

Left Side

Install Your Power Sensor

Do not use this sensor in hazardous (classified) locations or life safety applications.

Step 1: Prepare the included 25' speaker cable.

Your Power Sensor comes with one end of the 25' speaker wire already

attached to its contacts, which are non-polarized. Separate and strip the

leads on the free end of the speaker cable, exposing about ¼" of wire.

Step 2: Mount your Power Sensor.

1. Position your Power Sensor close enough to the power source that the power adapter

cord will reach. (Don't connect power yet—you'll do that in a later step.)

2. Mount your power sensor with screws through the flange holes, secure it with Velcro or

simply place it on a flat surface.

AVTECH Software, Inc.

Power

Port

Temperature & Environment Monitoring... Made Easy!

Power Sensor (RMA-PS1-SEN)

Installation Note

Dry Contacts

Right Side

AVTECH.com