アクセサリー Avtech RMA-PS1-SENのPDF インストールをオンラインで閲覧またはダウンロードできます。Avtech RMA-PS1-SEN 3 ページ。 Power sensor
ページを印刷する
AVTECH's Power Sensor monitors the on/off state of a power
source, such as main power, a UPS, surge protector or
standard wall outlet. Simply plug the Power Sensor into the
source you wish to monitor. When the power goes out, it sends
a signal to Room Alert. Install multiple Power Sensors to
generate alerts when one source fails and the back up takes
ove r.
Power Sensor Package Contents
One (1) Power Sensor ID box
One (1) 25' speaker cable
One (1) AVTECH power adapter
One (1) Installation Note (You're reading it now.)
The Power Sensor ID Box
Power
LED
Left Side
Install Your Power Sensor
Do not use this sensor in hazardous (classified) locations or life safety applications.
Step 1: Prepare the included 25' speaker cable.
Your Power Sensor comes with one end of the 25' speaker wire already
attached to its contacts, which are non-polarized. Separate and strip the
leads on the free end of the speaker cable, exposing about ¼" of wire.
Step 2: Mount your Power Sensor.
1. Position your Power Sensor close enough to the power source that the power adapter
cord will reach. (Don't connect power yet—you'll do that in a later step.)
2. Mount your power sensor with screws through the flange holes, secure it with Velcro or
simply place it on a flat surface.
AVTECH Software, Inc.
Power
Port
Temperature & Environment Monitoring... Made Easy!
Power Sensor (RMA-PS1-SEN)
Installation Note
Dry Contacts
Right Side
AVTECH.com