Dell PowerEdge 2550 Instructions pour l'installation du rack - Page 21

Parcourez en ligne ou téléchargez le pdf Instructions pour l'installation du rack pour {nom_de_la_catégorie} Dell PowerEdge 2550. Dell PowerEdge 2550 40 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 2550 : Manuel d'installation (26 pages), Manuel d'installation (32 pages), Manuel de configuration (10 pages), Manuel d'activation (32 pages), Manuel d'installation (32 pages), Manuel (28 pages), Manuel (15 pages)

F i g u r e 1 - 1 1 . I n s t a l l i n g t h e S l i d e A s s e m b l i e s f o r C e n t e r - M o u n t

C o n f i g u r a t i o n

12-24 x 0.5-inch

Phillips screw

(2 per bracket)

shoulder

washer

(2 per bracket)

locking nut

(2 per bracket)

Flush-Mount Installation

To prepare the RapidRails slide assemblies for flush-mount installation in the 2-post rack,

perform the following steps:

Locate the left slide assembly and place it on a smooth work surface. Place the right

slide assembly to the right of the left slide assembly. Position both rails so that the

center brackets are facing upwards.

NOTE: The slide assemblies are factory configured for center-mount use. For flush-mount

installation, you must remove, rotate 180 degrees, and reinstall the mounting bracket on

the opposite slide assembly.

Remove two locking nuts and two shoulder washers from each center bracket.

right slide

assembly

Ra c k In s ta l lati on Gui de

1-15