Dell E05B001 Manuel de référence - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} Dell E05B001. Dell E05B001 29 pages.

Imprimer la page
Dell E05B001 Manuel de référence
Option
Description
Option
Model
Drive Type
Capacity
NVMe Settings
The NVMe settings enable you to set the NVMe drives to either RAID mode or Non-RAID mode.
NOTE:
To configure these drives as RAID drives, click System BIOS Settings > SATA Settings > Embedded SATA
Option and enable RAID mode. If not, you must set this field to Non-RAID mode.
View NVMe settings
To view the NVMe Settings screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click NVMe Settings.
NVMe Settings details
About this task
The NVMe Settings screen details are explained as follows:
Option
Description
NVMe Mode
Enables you to set the NVMe mode. This option is set to Non RAID by default.
Boot Settings
You can use the Boot Settings screen to set the boot mode to either BIOS or UEFI. It also enables you to specify the boot
order.
● BIOS: The BIOS Boot Mode is the legacy boot mode. It is maintained for backward compatibility.
● UEFI: The Unified Extensible Firmware Interface (UEFI) is a new interface between operating systems and platform
firmware. The interface consists of data tables with platform related information, also boot and runtime service calls that are
available to the operating system and its loader. The following benefits are available when the Boot Mode is set to UEFI:
Description
Specifies the drive model of the selected device.
NOTE:
If no device is installed, it displays Unkown.
Specifies the type of drive attached to the SATA port.
NOTE:
If no device is installed, it displays Unkown Device.
Specifies the total capacity of the drive. This field is undefined for removable media
devices such as optical drives.
NOTE:
If no device is installed, it displays N/A.
BIOS and UEFI
13