Dell Force10 S2410 Manuel de démarrage rapide - Page 25

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dell Force10 S2410. Dell Force10 S2410 31 pages. Installing the s2410 system
Également pour Dell Force10 S2410 : Manuel (42 pages)

Imprimer la page

Enabling Spanning Tree Protocol

Spanning Tree Protocol (STP) is off by default. First, you must enable STP

globally. Next, enable STP on the desired ports. Using the CLI to enable STP, it

is possible to enable spanning tree globally and on all the ports with just two

commands.

Step Task

Enable STP globally.

Enable STP on all ports.

Create a Port-based VLAN

When you set up a management IP address, you can manage the switch through

any enabled port in VLAN1.

By default, the management VLAN is set up on the default VLAN 1, and

includes all ports. The default VLAN is VLAN 1. It cannot be changed.

NOTE: All ports are disabled by default. Enable them with no shutdown all

(Global Config mode), or individually with the no shutdown command.

Step Task

Specify a new or existing VLAN

by VLAN number.

Command Syntax

spanning-tree

spanning-tree port mode

enable all

Command Syntax

interface vlan vlan-id

Installing the Software

Command Mode

Config

Command Mode

Global Config