Dell Force10 S2410 빠른 시작 매뉴얼 - 페이지 25

{카테고리_이름} Dell Force10 S2410에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S2410 31 페이지. Installing the s2410 system
Dell Force10 S2410에 대해서도 마찬가지입니다: 매뉴얼 (42 페이지)

페이지 인쇄

Enabling Spanning Tree Protocol

Spanning Tree Protocol (STP) is off by default. First, you must enable STP

globally. Next, enable STP on the desired ports. Using the CLI to enable STP, it

is possible to enable spanning tree globally and on all the ports with just two

commands.

Step Task

Enable STP globally.

Enable STP on all ports.

Create a Port-based VLAN

When you set up a management IP address, you can manage the switch through

any enabled port in VLAN1.

By default, the management VLAN is set up on the default VLAN 1, and

includes all ports. The default VLAN is VLAN 1. It cannot be changed.

NOTE: All ports are disabled by default. Enable them with no shutdown all

(Global Config mode), or individually with the no shutdown command.

Step Task

Specify a new or existing VLAN

by VLAN number.

Command Syntax

spanning-tree

spanning-tree port mode

enable all

Command Syntax

interface vlan vlan-id

Installing the Software

Command Mode

Config

Command Mode

Global Config