Dell Inspiron 1000 Manuel d'entretien - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Dell Inspiron 1000. Dell Inspiron 1000 46 pages. Dell vostro 1000 quick setup guide
Également pour Dell Inspiron 1000 : Manuel de configuration (2 pages), Démontage du disque dur (9 pages), Spécifications (2 pages), Manuel de configuration (2 pages), Manuel de configuration (2 pages), Configuration de l'ordinateur (2 pages), Configuration de l'ordinateur (2 pages)

Imprimer la page

1 M2.5 x 5-mm screws (2)

4 grounding-wire and captive

screw

7 standby switch

12. Lift the display up and away from the computer.

NOTICE:

The standby switch is fragile and easily broken. Avoid knocking the switch when removing and replacing the display.

Replacing the Display Assembly

NOTE:

Ensure the display and antenna cables are not twisted and are clear of the computer base before replacing the display.

1. Place the display onto the computer base.

2. Replace the two M2.5 x 5-mm screws in the display hinge.

3. Securely route the display cable under the tabs in the cable channel.

4. Connect the display cable to the system board and tighten the captive screw.

5. Securely route the antenna cables under the tabs in the antenna cable channel. If a Mini-Card is installed, connect the antenna cables to the card (see

Replacing a

Mini-Card).

6. Replace the keyboard (see

7. Replace the hinge cover (see

8. Close the display.

9. Replace the two M2.5 x 8-mm screws in the back of the computer and replace the two screw covers.

10. Turn the computer over and replace the two M2.5 x 8-mm screws in the bottom of the computer.

Display Bezel

CAUTION:

Before you begin the following procedure, follow the safety instructions in the Product Information Guide.

2 display cable

5 antenna cables (2)

8 display cable connector on

system board

Replacing the

Keyboard).

Replacing the Hinge

Cover).

3 display cable pull-

tab

6 antenna cable

channel

9 display cable

channel