3 Day Blinds 2 1/2 Pour commencer - Page 2
Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} 3 Day Blinds 2 1/2. 3 Day Blinds 2 1/2 8 pages.
INSIDE MOUNT
• Facing the window, hold the end bracket marked "LH" in the
upper left hand corner of the window against the top and
side of the window casing.
• Position the front edge of the closed bracket:
• Flush with the front of the
window casing if you are
mounting your blind in a
window with the minimum
depth.
NOTE: Be sure to check for any obstructions such as window
cranks or which may require diff erent bracket locations.
2
| 2 & 2
/
" Wood & Faux Wood & Angled Slat Blinds
1
2
/
"
3
4
•
/
" back to have the
3
4
valance fl ush with the
front of the window
casing.
• Mark the window casing
through the holes in either
the side or top of the end
bracket. For maximum
stability, the marks should
be made diagonally.
• Using a drill with a
/
" drill
1
16
bit or an awl, make a small
pilot hole at each mark.
• Using a fl athead
screwdriver, open the
latches of the end
brackets.
• Mount the bracket
using two of the screws
provided.
• Repeat this procedure for
the right end bracket.
TO INSTALL CENTER SUPPORT BRACKETS:
• If your hardware packet includes one center support
bracket, position it as close to the top center of the window
casing as possible. If more than one center support bracket
has been provided, position them equidistant from the end
brackets and each other.
WARNING: Do not locate the center support brackets over
any of the moving parts in the headrail.
Proceed to "Valance Return Assembly".
• Align the back of the center
support bracket(s) with the
back end of the mounting
brackets. The alignment
is crucial for proper blind
installation.
• Mark the window casing
through the holes in the
top of the center support
bracket. For maximum
stability, the marks should be
made diagonally.
• Using a drill with a
/
" drill
1
16
bit or an awl, make a small
pilot hole at each mark.
• Mount each of the bracket(s)
using two of the screws
provided.