Dell PowerVault NX1950 Manuel d'installation et de dépannage - Page 25

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de dépannage pour {nom_de_la_catégorie} Dell PowerVault NX1950. Dell PowerVault NX1950 48 pages. For vmware esx server software
Également pour Dell PowerVault NX1950 : Manuel de déploiement (34 pages), Informations importantes Manuel (26 pages), Pour commencer (49 pages), Manuel de déploiement (38 pages), Manuel de mise à jour (18 pages), Manuel de référence (4 pages), Mise en place (2 pages), Utilisation (2 pages), Manuel de configuration (11 pages)

Managing Your Cluster

In the Dell™ PowerVault™ NX1950 cluster solution, all cluster nodes must

be configured with a Highly-Available File Server Instance to access the

resources of the cluster. This creates a cluster resource group that includes a

network name and IP address allowing the file shares that are provisioned on

the Highly-Available Server Instance to failover between nodes.

To create a Highly-Available Server Instance, follow the procedure below:

1 Go to the PowerVault NX1950 Management Console and launch the

PowerVault NX1950 Initial Configuration Tasks wizard.

2 Click File Server Management (Local).

3 In the Actions pane, click Edit Server Configuration to start the

creation wizard.

4 In the Customize this system section, click Create a highly available file

server instance.

5 After the Highly available file server instance wizard launches, enter the

name, IP address, and the Subnet mask for the IP address and then

click OK. The process of creating a highly-available server instance begins

and a progress bar indicates the status of this process.

NOTE:

When you create a Highly-Available Server Instance on a cluster node

using the PowerVault NX1950 Initial Configuration Tasks wizard, the status of the

Highly-Available Server Instance is not visible to the other nodes within the cluster.

This behavior is expected and is behaving as designed. To access the Highly-

Available Server Instance, each node in the cluster must have ownership of

the instance.

After this process is complete, all nodes have access to the cluster

resource group.

NOTE:

To set up Snapshots for iSCSI Targets, see the Dell PowerVault NX1950

Systems End-to-End Deployment Guide for iSCSI on the Dell Support website at

support.dell.com.

Managing Your Cluster