Dell PowerVault NX1950 Panduan Instalasi dan Pemecahan Masalah - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pemecahan Masalah untuk Penyimpanan Dell PowerVault NX1950. Dell PowerVault NX1950 48 halaman. For vmware esx server software
Juga untuk Dell PowerVault NX1950: Panduan Penyebaran (34 halaman), Panduan Informasi Penting (26 halaman), Memulai (49 halaman), Panduan Penyebaran (38 halaman), Panduan Peningkatan (18 halaman), Panduan Referensi (4 halaman), Menyiapkan (2 halaman), Menggunakan (2 halaman), Panduan Konfigurasi (11 halaman)

Managing Your Cluster

In the Dell™ PowerVault™ NX1950 cluster solution, all cluster nodes must

be configured with a Highly-Available File Server Instance to access the

resources of the cluster. This creates a cluster resource group that includes a

network name and IP address allowing the file shares that are provisioned on

the Highly-Available Server Instance to failover between nodes.

To create a Highly-Available Server Instance, follow the procedure below:

1 Go to the PowerVault NX1950 Management Console and launch the

PowerVault NX1950 Initial Configuration Tasks wizard.

2 Click File Server Management (Local).

3 In the Actions pane, click Edit Server Configuration to start the

creation wizard.

4 In the Customize this system section, click Create a highly available file

server instance.

5 After the Highly available file server instance wizard launches, enter the

name, IP address, and the Subnet mask for the IP address and then

click OK. The process of creating a highly-available server instance begins

and a progress bar indicates the status of this process.

NOTE:

When you create a Highly-Available Server Instance on a cluster node

using the PowerVault NX1950 Initial Configuration Tasks wizard, the status of the

Highly-Available Server Instance is not visible to the other nodes within the cluster.

This behavior is expected and is behaving as designed. To access the Highly-

Available Server Instance, each node in the cluster must have ownership of

the instance.

After this process is complete, all nodes have access to the cluster

resource group.

NOTE:

To set up Snapshots for iSCSI Targets, see the Dell PowerVault NX1950

Systems End-to-End Deployment Guide for iSCSI on the Dell Support website at

support.dell.com.

Managing Your Cluster