Dell PowerVault NX1950 Panduan Instalasi dan Pemecahan Masalah - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pemecahan Masalah untuk Penyimpanan Dell PowerVault NX1950. Dell PowerVault NX1950 48 halaman. For vmware esx server software
Juga untuk Dell PowerVault NX1950: Panduan Penyebaran (34 halaman), Panduan Informasi Penting (26 halaman), Memulai (49 halaman), Panduan Penyebaran (38 halaman), Panduan Peningkatan (18 halaman), Panduan Referensi (4 halaman), Menyiapkan (2 halaman), Menggunakan (2 halaman), Panduan Konfigurasi (11 halaman)

Halaman Cetak
Dell PowerVault NX1950 Panduan Instalasi dan Pemecahan Masalah

Creating a Highly Available iSCSI Target Using Microsoft iSCSI Target 3.0

1 Click Start→ Administrative Tools→ Services→ Microsoft iSCSI Software
Target→ (right-click) Stop, to stop the iSCSI service.
2 Stop the Microsoft
3 On the Active node, go to Start
Administrator
4 Enter the following required information and click Next:
–
Name
–
Description
–
Resource Type: Select Generic Service
–
Group: Select Cluster Group
5 Verify that all cluster nodes are in the Possible Owners window and click
Next.
6 Select the following dependencies, click Add, and then click Next:
–
Cluster IP Address
–
Cluster Name
–
Physical Disk of Choice
NOTE:
7 In the Service Name field, type WinTarget, and then click Next.
8 When prompted for the registry key, click Add, type
Software\Microsoft\iSCSI Target, and then click Finish.
9 Right-click on Resource and select Online.
10 On the active node, go to PowerVault NX1950 Management Console
Microsoft iSCSI Software Target
11 Select the physical disk that you chose in step 6. Right-click on the disk
and complete the wizard steps to create a LUN.
12 Right-click Microsoft iSCSI Software Target and then click Create New
Target.
13 Right-click the new Target and add the existing LUN that you created in
step 11.
NOTE:
If you are migrating from Microsoft Target 3.0 to Microsoft Target 3.1, see
the Dell PowerVault NX1950 Systems Solution Upgrade Guide.
26
Managing Your Cluster
®
iSCSI service on each cluster node and set it to Manual.
→
→
Groups
Cluster Group (right-click)
Do not select quorum disk.
→
Administrative Tools
→
Devices.
→
Cluster
→
New Resource.
→