3 Day Blinds HONEYCOMB SHADES UltraLift Cordless Pour commencer - Page 3

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} 3 Day Blinds HONEYCOMB SHADES UltraLift Cordless. 3 Day Blinds HONEYCOMB SHADES UltraLift Cordless 5 pages.

Imprimer la page

SHADE INSTALLATION

If you have not already done so, unwrap the cellophane from

around the shade. DO NOT CUT the cellophane as the fabric

or the cords supporting the shade may be inadvertently cut.

• Hold the shade up near the brackets and insert the front

clip of the bracket into the front groove of the rail.

• Make sure the shade is centered in the window opening.

• Push the rail back and up until the back clips of the bracket

are inserted in the back groove of the rail.

SHADE OPERATION

• Press the button on the handle to raise or lower the

moveable rails. The rails will stay in position when the button

is released.

3 | Honeycomb Shades UltraLift Cordless™

LEVEL THE MOVING RAIL(S) (if necessary)

If the bottom rail of the shade is not level, it can be adjusted

by following the procedure below.

• When the rail is level, replace the tool and the endcap.

SHADE REMOVAL

Draw the shade completely up. (See "Shade Operation")

Push shade rail back and rotate the back of the shade down

to release.

• Rotate the back of the headrail down and carefully lift the

headrail off of the front hooks of the mounting brackets.

• Remove the right end cap

from the bottom rail.

• Pull out the section

labeled TOOL.

• Push in on the adjustment

screw with the tool and turn

to adjust the rail. Turning

clockwise will move the rail

down, counterclockwise will

move the rail up.