3 Day Blinds HONEYCOMB SHADES UltraLift Cordless Pour commencer - Page 4

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} 3 Day Blinds HONEYCOMB SHADES UltraLift Cordless. 3 Day Blinds HONEYCOMB SHADES UltraLift Cordless 5 pages.

Imprimer la page

OPTIONAL ACCESSORIES

EXTENSION BRACKETS

Optional extension brackets are used to project the back of

the shade up to 2

" from the mountain surface.

Nut

Bolt

Extension Bracket

• Attach each mounting bracket to an extension bracket using

the nuts bolts and washers provided.

• Mount the extension bracket to the wall per the instructions

for an "Outside Mount", using a level and making certain

that all mounting brackets are level and project the same

distance from the mounting surface. For maximum stability,

install the screws diagonally from one another.

• Install the shade per the directions for "Shade Installation".

SPACERS

Spacer

Spacers are available for use on windows with a projected

molding. They are

" thick and allow the shade to be

mounted flush with the outside edge of any standard

window molding. They are available by contacting

our Customer Care Department at 800-800-3329.

4 | Honeycomb Shades UltraLift Cordless™

HOLD DOWN BRACKETS

Hold down brackets are used primarily on shades mounted to

doors or in motor homes. There are two small holes in the end

caps that are covered by a thin plastic layer. Use the pin on

the hold down bracket to push through the center of the end

cap and it will break through the plastic layer.

• With the shade lowered to it's full length, place the pin of

each hold down bracket into the hole in each end of the

minimum

bottom rail.

• Mark the mounting surface, either to the side or back of the

window frame, through the holes in the hold down bracket.

Make sure the hold down brackets are level and aligned with

each other.

• Raise the shade and screw the hold down brackets into the

mounting surface using the screws provided.

• Lower the shade and flex the

hold down bracket outward

so that the pin can be

inserted into the hole in the

end cap.