Dell Force10 S4810 Manuel de démarrage rapide - Page 23
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dell Force10 S4810. Dell Force10 S4810 27 pages. Dell force10 s4810 switch
Également pour Dell Force10 S4810 : Manuel de déploiement (36 pages), Manuel de configuration (17 pages), Manuel de configuration (17 pages)
Imprimer la page
Step Task
Configure an interface
2
as untagged. This
command is available
only in VLAN
interfaces.
Assign an IP address to a VLAN
VLANs are a Layer 2 feature. For two physical interfaces on different VLANs
to communicate, you must assign an IP address to the VLANs to route traffic
between the two interfaces. The shutdown command in INTERFACE mode
does not affect Layer 2 traffic on the interface.
NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,
is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command.
Task
Configure an IP address
and mask on the interface.
Connecting the S4810 to the Network
Once you have completed the hardware installation and software configuration
for the S4810, you can connect to your company network by following your
company's cabling requirements.
Command Syntax
untagged interface
Command Syntax
ip address ip-address mask
[secondary]
Command Mode
INTERFACE
Command Mode
INTERFACE
Installing the Software
19