Dell Force10 S4810 Manuel de déploiement - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de déploiement pour {nom_de_la_catégorie} Dell Force10 S4810. Dell Force10 S4810 36 pages. Dell force10 s4810 switch
Également pour Dell Force10 S4810 : Manuel de démarrage rapide (27 pages), Manuel de configuration (17 pages), Manuel de configuration (17 pages)
Flow Setup
This chapter describes the configuration options required to set up flows.
Sample Topology
In the following sample topology, two OF instances are shown. of-instance 1 has an interface type of
demonstrates ACL and L3 flows. of-instance 2 has an interface type of
flows. LB and L2 flows are supported on OF VLANs only.
Figure 1. SDN Sample Topology
Use the show running-config openflow of-instance 1 command to display the following information:
FTOS# show running-config openflow of-instance 1
!
openflow of-instance 1
controller 1 10.11.205.184
flow-map l3 enable
multiple-fwd-table enable
no shutdown
FTOS# show openflow of-instance 1
Instance
: 1
Admin State
: Up
Interface Type
: Port
DP Id
: 00:01:00:01:e8:8b:1a:30
Forwarding Tbls : acl,mac,route
Flow map
: l3
LB assist
: disabled
EchoReq interval: 15 seconds
Connect interval: 15 seconds
Number of Flows : 1 (rt:1)
Packets (acl)
: -
Bytes (acl)
: -
Controller 1
: TCP, 10.11.205.184/6633, connected (equal)
VLAN and demonstrates ACL, L2, LB, and L3
tcp
4
port and
13