- ページ 13

スイッチ Dell Force10 S4810のPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S4810 36 ページ。 Dell force10 s4810 switch
Dell Force10 S4810 にも：クイック・スタート・マニュアル (27 ページ), 設定マニュアル (17 ページ), 設定マニュアル (17 ページ)

ページを印刷する

Flow Setup

This chapter describes the configuration options required to set up flows.

Sample Topology

In the following sample topology, two OF instances are shown. of-instance 1 has an interface type of

demonstrates ACL and L3 flows. of-instance 2 has an interface type of

flows. LB and L2 flows are supported on OF VLANs only.

Figure 1. SDN Sample Topology

Use the show running-config openflow of-instance 1 command to display the following information:

FTOS# show running-config openflow of-instance 1

openflow of-instance 1

controller 1 10.11.205.184

flow-map l3 enable

multiple-fwd-table enable

no shutdown

FTOS# show openflow of-instance 1

Instance

: 1

Admin State

: Up

Interface Type

: Port

DP Id

: 00:01:00:01:e8:8b:1a:30

Forwarding Tbls : acl,mac,route

Flow map

: l3

LB assist

: disabled

EchoReq interval: 15 seconds

Connect interval: 15 seconds

Number of Flows : 1 (rt:1)

Packets (acl)

: -

Bytes (acl)

: -

Controller 1

: TCP, 10.11.205.184/6633, connected (equal)

VLAN and demonstrates ACL, L2, LB, and L3

tcp

port and