Dell Force10 S60 Series Manuel - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dell Force10 S60 Series. Dell Force10 S60 Series 45 pages.
Également pour Dell Force10 S60 Series : Manuel de démarrage rapide (29 pages)

Imprimer la page

Figure 3-6. Three S60 Systems with 1-port, 24G Stacking Modules Connected in a Ring Topology

Supply Power and Power Up the System

Supply power to the S60 system after you have mounted them in a rack (or on a table) and have installed

the optional modules.

Dell Networking recommends re-inspecting your system prior to powering up. Verify that:

• the equipment is properly secured to the rack and properly grounded.

• the equipment rack is properly mounted and grounded.

• the ambient temperature around the system (which may be higher than the room temperature) is within

the limits specified for the S60 system.

• there is sufficient airflow around the system.

• the input circuits are correctly sized for the loads and that you use sufficient over-current protection

devices.

• all the protective covers are in place.

• you have installed blank panels if you did not install optional modules.

NOTE: A US AC power cable is included in the shipping container for powering up an AC PSU. You must

order all other power cables separately.

WARNING: ESD damage can occur if the components are mishandled. Always wear an ESD-preventive wrist

or heel ground strap when handling the S60 system and its components.

Power Up Sequence

When the system powers up, the fans immediately come on at high speed. The fan speed slows as the

system boots up.

Install the S60 System