Dell PowerConnect M8024 Manuel de configuration - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Dell PowerConnect M8024. Dell PowerConnect M8024 21 pages. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Également pour Dell PowerConnect M8024 : Note de mise à jour (9 pages), Notes de mise à jour (27 pages), Mise à jour du micrologiciel (24 pages)
Imprimer la page
2
Dell recommended switch configuration for 8024 and
8024F
These steps show how to configure two PowerConnect 8024 or 8024F series switches with a LAG. The
switches are interconnected using four 10 GbE Small Form-factor Pluggable (SFP+) ports, and the LAG is
configured for Dynamic Link Aggregation Control Protocol (LACP).
For configuring M8024 and M8024-k with a LAG, skip to Section 3. For configuring PowerConnect 8024
or 8024F series switches in a virtual stack configuration, skip to Section 4.
2.1
Cabling diagram for 8024 and 8024F
The cabling diagram shown below represents the Dell recommend method for deploying your servers and
EqualLogic arrays.
Figure 1
6
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs
Cabling diagram