- ページ 6

スイッチ Dell PowerConnect M8024のPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerConnect M8024 21 ページ。 Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Dell PowerConnect M8024 にも：リリースノート (9 ページ), リリースノート (27 ページ), ファームウェアのアップグレード (24 ページ)

ページを印刷する

Dell recommended switch configuration for 8024 and

8024F

These steps show how to configure two PowerConnect 8024 or 8024F series switches with a LAG. The

switches are interconnected using four 10 GbE Small Form-factor Pluggable (SFP+) ports, and the LAG is

configured for Dynamic Link Aggregation Control Protocol (LACP).

For configuring M8024 and M8024-k with a LAG, skip to Section 3. For configuring PowerConnect 8024

or 8024F series switches in a virtual stack configuration, skip to Section 4.

2.1

Cabling diagram for 8024 and 8024F

The cabling diagram shown below represents the Dell recommend method for deploying your servers and

EqualLogic arrays.

Figure 1

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs

Cabling diagram