Dell PowerEdge 6400 Manuel d'installation - Page 24

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell PowerEdge 6400. Dell PowerEdge 6400 37 pages. Wake-on-lan (wol) support on dell servers
Également pour Dell PowerEdge 6400 : Installation du rack (37 pages), Manuel d'installation de la mise à niveau (42 pages), Installation du rack (34 pages), Manuel d'installation (42 pages), Manuel (10 pages), Installation (4 pages), Assemblage et installation (32 pages), Manuel (10 pages), Manuel (15 pages)

05KCEeb1.fm Page 8 Thursday, September 14, 2000 1:37 PM

5HY ),/( /2&$7,21 5???0XOWL?9?.&(HEIP

1-8

Rack Installation Guide

Installing the Slide Assemblies in the Rack

You must allow 7 U (12.25 inches) of vertical space for each PowerEdge system you

install in the rack.

The rails of the rack are marked by small indentations in 1-U increments (see

Figure 1-6).

1 U (1.75 inches)

For more information, see the Dell Rack Advisor software available on the Dell World

Wide Web site at http://support.dell.com.

WARNING: If you are installing more than one computer, install the slide

assemblies so that the first computer is installed in the lowest available

position in the rack.

To determine where to install the slide assemblies in the rack, perform the following

steps:

Place the front of the template over the front rack rails (see Figure 1-7).

The printing on the template identifies the side facing outward as the template

front.

Position the bottom of the template where the system's lower edge will be

located.

'(// &21),'(17,$/ 3UHOLPLQDU\