Dell PowerEdge 6400 Руководство по установке - Страница 24

Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель Dell PowerEdge 6400. Dell PowerEdge 6400 37 страниц. Wake-on-lan (wol) support on dell servers
Также для Dell PowerEdge 6400: Установка стойки (37 страниц), Руководство по установке обновления (42 страниц), Установка стойки (34 страниц), Руководство по установке (42 страниц), Руководство (10 страниц), Установка (4 страниц), Сборка и установка (32 страниц), Руководство (10 страниц), Руководство (15 страниц)

Печатать страницу
Dell PowerEdge 6400 Руководство по установке
05KCEeb1.fm Page 8 Thursday, September 14, 2000 1:37 PM
5HY ),/( /2&$7,21 5???0XOWL?9?.&(HEIP
1-8
Rack Installation Guide

Installing the Slide Assemblies in the Rack

You must allow 7 U (12.25 inches) of vertical space for each PowerEdge system you
install in the rack.
The rails of the rack are marked by small indentations in 1-U increments (see
Figure 1-6).
1 U (1.75 inches)

Figure 1-6. One Rack Unit

For more information, see the Dell Rack Advisor software available on the Dell World
Wide Web site at http://support.dell.com.
WARNING: If you are installing more than one computer, install the slide
assemblies so that the first computer is installed in the lowest available
position in the rack.
To determine where to install the slide assemblies in the rack, perform the following
steps:
1.
Place the front of the template over the front rack rails (see Figure 1-7).
The printing on the template identifies the side facing outward as the template
front.
2.
Position the bottom of the template where the system's lower edge will be
located.
'(// &21),'(17,$/ 3UHOLPLQDU\