Dell S4148FE Manuel d'installation - Page 37
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell S4148FE. Dell S4148FE 48 pages.
Imprimer la page
Besides the 10/100/1000Base-T RJ-45 ports, the S4100–ON Series (S4128F-ON, S4148F-ON, and S4148FE-ON) switch provides several
ports for management and storage.
NOTE:
The output examples in this section are for reference only. Your output may vary.
Topics:
•
RS-232 console port access
•
USB storage
•
USB-B console port access
•
Before you install an OS
•
ONIE service discovery
RS-232 console port access
The RS-232 console port is on the PSU-side of the switch, as shown.
Figure 22. RS-232 console port
1
RJ-232 console port
CAUTION:
Ensure that any equipment attached to the serial port can support the required 115200 baud rate.
NOTE:
Before starting this procedure, ensure your PC has a 9-pin serial port. You must have a terminal emulation program
already installed and running on your PC.
NOTE:
If your PC's serial port cannot accept a female DB-9 connector, use a DB-9 male-to-male adaptor.
1
Install the provided RJ-45 connector side of the provided cable into the S4100-ON Series console port.
2
Install the DB-9 female side of the provided copper cable into your PC's serial port. Or install the DB-9 cable into other data terminal
equipment (DTE) server hardware that you intend to use.
3
Keep the default terminal settings on the console as follows:
•
115200 baud rate
•
No parity
•
8 data bits
Management ports
Management ports
7
37