Dell Z9100-ON Manuel d'installation - Page 37

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Dell Z9100-ON. Dell Z9100-ON 45 pages. Open networking
Également pour Dell Z9100-ON : Manuel d'installation (45 pages), Manuel d'installation (43 pages)

Imprimer la page

4. Add a device to the file systems table (fstab) and mount the file systems—recommended.

ONIE:/ # vi /etc/fstab

# FSTAB entry for the ONIE-BOOT partition mounted on /boot

LABEL=ONIE-BOOT /mnt/onie-boot ext4

/dev/sdb

ONIE:/ # mount -a

Before you install an OS

After powering on the Z9100-ON switch, it goes through a power-on self-test (POST).

POST runs every time the switch is initialized and checks the hardware components to determine if the switch is fully

operational before booting. After POST, the switch uses the Grub bootloader.

To select an entry, use the up and down arrow keys. Press Enter to select an OS or enter e to edit the commands before

booting. Enter c for a command line. The selected entry runs automatically in the operating system.

Example of the Grub bootloader

GNU GRUB

version 2.02~beta2+e4a1fe391

+-------------------------------------------+

|*ONIE: Install OS

| ONIE: Rescue

| ONIE: Uninstall OS

| ONIE: Update ONIE

| ONIE: Embed ONIE

| ONIE: Diag ONIE

+-------------------------------------------+

Your switch comes with ONIE installed.

Example of ONIE

ONIE: Install OS

For downloading and installing an OS from a URL

Starts ONIE with ONIE Discovery Service

(factory default boot)

ONIE: Rescue

Starts ONIE without ONIE Discovery Service

Useful for running Diagnostics manually

ONIE: Uninstall OS

Restore to factory defaults erases any installed OS

ONIE: Update ONIE

For downloading and updating ONIE from a URL

ONIE: Embed ONIE

For downloading and updating ONIE from a URL and erases any installed OS

ONIE: Diag ONIE

Run Diagnostic package for Z9100-ON

During the initial setup, the switch boots to ONIE Install. ONIE Install boots with ONIE Discovery to the console (ONIE:).

NOTE:

For more information, see the Open Networking Hardware Diagnostic Guide for the Z9100–ON System.

NOTE:

After you have securely installed and powered on the Z9100-ON, to configure your switch, see your third-party

ONIE-compatible OS or the Dell EMC OS documentation.

/mnt/usb

vfat

defaults,rw,errors=remount-ro 0

defaults

Management ports