EarthWay EV-N-Spred C22HDS Manuel d'assemblage et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage et d'utilisation pour {nom_de_la_catégorie} EarthWay EV-N-Spred C22HDS. EarthWay EV-N-Spred C22HDS 6 pages. Broadcast spreader
Également pour EarthWay EV-N-Spred C22HDS : Manuel d'assemblage et d'utilisation (8 pages), Manuel d'assemblage et d'utilisation (6 pages)

EarthWay EV-N-Spred C22HDS Manuel d'assemblage et d'utilisation
7.
N
: B
OTE
EFORE INSTALLING THE
H
S
,
THE
ANDLE
HAFT
SELECT THE BEST POSITION FOR THE
can select lower, middle, or upper positions for best fit to the operator's height. Insert 2-¾"
bolt through the Gauge, then upper handle and finally through handle shaft. See example to
the right.
DO NOT TIGHTEN LOCKNUT YET.
8.
Insert pivot rod into shut off plate as shown above. [T
from the top, then push down & turn to lock in place.]
9.
Insert other end of pivot rod into pivot and bracket assembly as shown. [T
end from the side that has the angle attached to the bracket, then turn to lock in place as
shown at the right and above. The correct positioning of the Pivot Bracket has the Angle and
Attaching Arm facing away from the gearbox.]
G
& L
A
AUGE
EVER
SSEMBLY AND
O
PERATOR
: Insert rod end with extra bend
IP
6.
Install drive wheel to axle using pin hole nearest
to lower handles as shown. Insert 2" cotter pin
through wheel and through axle. Bend with pliers to
prevent pin from falling out.
N
EXT
Install coast wheel to axle using outside pin hole as
shown on the left, insert 1" cotter pin through axle
[N
: not thru the wheel]. Bend with pliers to
OTE
prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO
WHEELS
U
H
PPER
ANDLE TO
'
. You
S COMFORT
: Insert rod
IP
Angle
Attaching
Arm
PAGE 3