- ページ 3
スプレッダー EarthWay EV-N-Spred C22HDSのPDF 組立・取扱説明書をオンラインで閲覧またはダウンロードできます。EarthWay EV-N-Spred C22HDS 6 ページ。 Broadcast spreader
EarthWay EV-N-Spred C22HDS にも： 組立・取扱説明書 (8 ページ), 組立・取扱説明書 (6 ページ)
ページを印刷する
7.
N
: B
OTE
EFORE INSTALLING THE
H
S
,
THE
ANDLE
HAFT
SELECT THE BEST POSITION FOR THE
can select lower, middle, or upper positions for best fit to the operator's height. Insert 2-¾"
bolt through the Gauge, then upper handle and finally through handle shaft. See example to
the right.
DO NOT TIGHTEN LOCKNUT YET.
8.
Insert pivot rod into shut off plate as shown above. [T
from the top, then push down & turn to lock in place.]
9.
Insert other end of pivot rod into pivot and bracket assembly as shown. [T
end from the side that has the angle attached to the bracket, then turn to lock in place as
shown at the right and above. The correct positioning of the Pivot Bracket has the Angle and
Attaching Arm facing away from the gearbox.]
G
& L
A
AUGE
EVER
SSEMBLY AND
O
PERATOR
: Insert rod end with extra bend
IP
6.
Install drive wheel to axle using pin hole nearest
to lower handles as shown. Insert 2" cotter pin
through wheel and through axle. Bend with pliers to
prevent pin from falling out.
N
EXT
Install coast wheel to axle using outside pin hole as
shown on the left, insert 1" cotter pin through axle
[N
: not thru the wheel]. Bend with pliers to
OTE
prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO
WHEELS
U
H
PPER
ANDLE TO
'
. You
S COMFORT
: Insert rod
IP
Angle
Attaching
Arm
PAGE 3