ALLIGATOR sens.it RetroFIT-kit 2.0 Manuel d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} ALLIGATOR sens.it RetroFIT-kit 2.0. ALLIGATOR sens.it RetroFIT-kit 2.0 18 pages. Pressure monitoring system

Imprimer la page

Note:

The RetroFIT kit display must only be opened in the scope of battery replacement or

for the initial commissioning. Proceed in strict compliance with the instructions under

"Display - Initial steps / battery replacement". Any deviation renders all warranty claims

void. Opening of the other products included in the scope of supply, attempts at

manipulation or repair and unintended operation render the warranty void.

Note: Battery replacement for the sensors is not possible.

1.4 Installing the display in the vehicle

Proceed as follows to mount the display in the vehicle:

In order to achieve the best possible adhesive effect in the following step,

attempt to fasten the mounting plate on a level surface on the instrument

panel. Please ensure that the surface is free from dirt, silicone, wax, etc.

Now remove the protective film on the self-adhesive side of the mounting

plate. (Figure 10)

Now press the mounting plate on the selected area and apply pressure for

approx. 30 seconds. (Figure 11)

Now the rear side of the display can be fastened on the magnet positioned

on the mounting plate. The display is now held in place on the mounting

plate by the magnetic force. (Figure 12)