ALLIGATOR sens.it RetroFIT-kit 2.0 운영 매뉴얼 - 페이지 6

{카테고리_이름} ALLIGATOR sens.it RetroFIT-kit 2.0에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLIGATOR sens.it RetroFIT-kit 2.0 18 페이지. Pressure monitoring system

페이지 인쇄

Note:

The RetroFIT kit display must only be opened in the scope of battery replacement or

for the initial commissioning. Proceed in strict compliance with the instructions under

"Display - Initial steps / battery replacement". Any deviation renders all warranty claims

void. Opening of the other products included in the scope of supply, attempts at

manipulation or repair and unintended operation render the warranty void.

Note: Battery replacement for the sensors is not possible.

1.4 Installing the display in the vehicle

Proceed as follows to mount the display in the vehicle:

In order to achieve the best possible adhesive effect in the following step,

attempt to fasten the mounting plate on a level surface on the instrument

panel. Please ensure that the surface is free from dirt, silicone, wax, etc.

Now remove the protective film on the self-adhesive side of the mounting

plate. (Figure 10)

Now press the mounting plate on the selected area and apply pressure for

approx. 30 seconds. (Figure 11)

Now the rear side of the display can be fastened on the magnet positioned

on the mounting plate. The display is now held in place on the mounting

plate by the magnetic force. (Figure 12)