Christie CP2230 Fiche d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Fiche d'instruction pour {nom_de_la_catégorie} Christie CP2230. Christie CP2230 9 pages. Christie rack mount pedestal
Également pour Christie CP2230 : Fiche d'instruction (6 pages), Bulletin technique (6 pages), Bulletin technique (8 pages), Manuel (2 pages), Manuel d'installation et de configuration (19 pages)

2. On the CP2000-X/-XB or Roadie 25K/HD+30K/HD+35K, remove the center (8 screws) and front

belly pan (4 screws), as shown in Figure 2.

3. Prime/Purge of Air: Power up the projector (no lamp). Manipulate or "prime" all coolant hoses

by flicking, pinching and raising them as necessary (Figure 3) to keep liquid moving and flowing

to-and-from the pump. You must purge the system of all air, otherwise the coolant will not flow

properly and may cause the DMDs to overheat. NOTE: The coolant in the reservoir disappears

into the system immediately after the pump has been started. You must continually refill the

reservoir until the coolant level stops falling.

CAUTION! Purge all hoses of air! On CP2000-X/-XB and Roadie 25K/HD+30K/

HD+35K, check hoses in belly pan area.

2 of 9

Figure 2 Remove Belly Pans

Figure 3 Refill the System & Prime

all Hoses to Eliminate Air Locks

Coolant Refill Instruction Sheet

020-100686-01 Rev. 1 (03-2011)