Allmatic ARGO 1 Series Manuel

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Allmatic ARGO 1 Series. Allmatic ARGO 1 Series 9 pages. Switchboards, programmable for 1 or 2 motors with independent slowdown control

Imprimer la page

SWITCHBOARDS, PROGRAMMABLE FOR 1 OR 2 MOTORS

IMPORTANT: DO NOT INSTALL THE SWITCHBOARD BEFORE READING THE INSTRUCTIONS!!!!

1. Introduction.

The Argo control unit is an apparatus fit to manage operation and control of 1 or 2 wing gates with 230V AC motors and power of up to 600W each.

The time functioning of the control unit, being of electronic type, is extremely precise. It is however possible that, due to the type of the motor

normally utilised, the corner of the travelling time of the wing is strongly influenced by the frictions that the wing self meets during the

course.

Consequently , also if the time is correctly set, the corner of the wings' opening can not be always the same wished.

Therefore it is advisable that the installer considers it, increasing, if necessary, the times of work in the more consonant measure with

the installation and making anyway attention to the fact that an excessive increasing of the time could mask the slowing down in opening

and in closure (see paragraph 6).

For the correct functioning it is also necessary the installation of the mechanical stops in opening and in closure (see pag. 6).

2. Configuration.

Trimmer of

regulation

Molex radio

module

Connector

radio

module

Dip-switch

3. Electrical connections.

Motor 2

Motor 1

6-1622192

rev. 14

21/09/2012

ARGO 1 - ARGO 2 SERIES

WITH INDEPENDENT SLOWDOWN CONTROL

Power supply

230 Vac 50 Hz.

Flashing light 230 Vac 60W max

N.B.: Use flashing light B.RO LIGHT FIX.

ITA

Indicator of open gate

Photocells

24 Vac 2W max.

power supply

(see par.7.6)

)

(Without autoflashing circuit

ENG

FRA

ESP

DEU

POR

Fuse

Electrolock output

12 Vac 12W Max

Table of contents:

FOTO CH = Photocell closing

FOTO AP = Photocell opening

AP = open

CH = close

Com = Common

PP = step by step button

Ant = Antenna

PED = Pedestrian button

F.C. 1 = limit switch 1

F.C. 2 = limit switch 2

Any control or safety device de-

signed for acting as a Normally

Closed (N.C.) contact, must be

provided with a jumper, if not

used.

Connector

transformer

Learning

button

9 10 11 12

1/9