Allmatic ARGO 1 Series Manuel
Kontrol Ünitesi Allmatic ARGO 1 Series için çevrimiçi göz atın veya pdf Manuel indirin. Allmatic ARGO 1 Series 9 sayfaları. Switchboards, programmable for 1 or 2 motors with independent slowdown control
SWITCHBOARDS, PROGRAMMABLE FOR 1 OR 2 MOTORS
IMPORTANT: DO NOT INSTALL THE SWITCHBOARD BEFORE READING THE INSTRUCTIONS!!!!
1. Introduction.
The Argo control unit is an apparatus fit to manage operation and control of 1 or 2 wing gates with 230V AC motors and power of up to 600W each.
The time functioning of the control unit, being of electronic type, is extremely precise. It is however possible that, due to the type of the motor
normally utilised, the corner of the travelling time of the wing is strongly influenced by the frictions that the wing self meets during the
course.
Consequently , also if the time is correctly set, the corner of the wings' opening can not be always the same wished.
Therefore it is advisable that the installer considers it, increasing, if necessary, the times of work in the more consonant measure with
the installation and making anyway attention to the fact that an excessive increasing of the time could mask the slowing down in opening
and in closure (see paragraph 6).
For the correct functioning it is also necessary the installation of the mechanical stops in opening and in closure (see pag. 6).
2. Configuration.
Trimmer of
regulation
Molex radio
module
Connector
radio
module
Dip-switch
3. Electrical connections.
Motor 2
Motor 1
6-1622192
rev. 14
21/09/2012
ARGO 1 - ARGO 2 SERIES
WITH INDEPENDENT SLOWDOWN CONTROL
Power supply
230 Vac 50 Hz.
Flashing light 230 Vac 60W max
N.B.: Use flashing light B.RO LIGHT FIX.
ITA
Indicator of open gate
Photocells
24 Vac 2W max.
power supply
(see par.7.6)
)
(Without autoflashing circuit
ENG
FRA
ESP
DEU
POR
Fuse
Electrolock output
12 Vac 12W Max
Table of contents:
FOTO CH = Photocell closing
FOTO AP = Photocell opening
AP = open
CH = close
Com = Common
PP = step by step button
Ant = Antenna
PED = Pedestrian button
F.C. 1 = limit switch 1
F.C. 2 = limit switch 2
Any control or safety device de-
signed for acting as a Normally
Closed (N.C.) contact, must be
provided with a jumper, if not
used.
3
4
5
6
Connector
transformer
Learning
button
7
8
9 10 11 12
1/9