Allmatic BAXS900 Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Allmatic BAXS900. Allmatic BAXS900 13 pages. For rolling shutters

Imprimer la page
Allmatic BAXS900 Manuel
WARNING!
- Do not use control buttons that can simultaneously control the two directions of rotation.
- BAXS900 is equipped with a standard power supply cable (Fig. 1
one with the same characteristics, only by qualified personnel.
- The STOP input is to be considered only a contact for the control of a functional STOP. It is not suitable for
connecting safety devices.
5. TRANSMITTERS LEARNING / PROGRAMMING
5.1) PROGRAMMING TECH3 PLUS (3 BUTTONS: OPEN - STOP - CLOSE). SET DIP 4 OFF POSITION
1.
Press and release the "RADIO LEARN" button (top right of the control panel).
2.
The control panel will begin to emit intermittent acoustic signals to indicate the start of
programming mode.
3.
Press and release sequentially (maximum 3 seconds between one key and the other)
the keys 1, 2 and 3. At each press the control panel will confirm the programming with
an acoustic signal. ATTENTION! The first button pressed will always be the OPEN/
ASCENT direction.
4.
Once the third button (CLOSE/DESCENT) is pressed, the control panel will give an
extended beep.
5.
The control panel will give 2 short and close acoustic signals (which indicate the exit
from the learning/programming moadality).
6.
Repeat the procedure (steps 1 to 5) for all additional transmitters.
"RADIO LEARN"
5.2) PROGRAMMING B.RO2WN. (2 BUTTONS: GO - STOP). SET DIP 4 ON POSITION
1.
Press and release the "RADIO LEARN" button (top right of the control panel).
2.
The control panel will begin to emit intermittent acoustic signals to indicate the start of
programming mode.
3.
Press and release sequentially (maximum 3 seconds between one key and the other)
the keys 1 and 2. At each press the control panel will confirm the programming with an
acoustic signal.
4.
Once the second button (STOP) is pressed, the control panel will give an extended
beep.
5.
The control panel will give 2 short and close acoustic signals (which indicate the exit
from the learning/programming moadality).
6.
Repeat the procedure (steps 1 to 5) for all additional transmitters.
6-1622623 rev. 3
OPEN BUTTON
). If damaged it must be replaced, with
STOP BUTTON
OPEN
STOP
CLOSE
TECH3 PLUS
CLOSE BUTTON
B.RO2WN
5 / 12