Miele DA 3160 Instructions d'utilisation et d'installation - Page 25

Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Miele DA 3160. Miele DA 3160 40 pages. Ventilation system
Également pour Miele DA 3160 : Instructions d'utilisation et d'installation (36 pages), Dimensions (1 pages), Instructions d'utilisation et d'installation (40 pages), Instructions d'utilisation et d'installation (40 pages), Instructions d'utilisation et d'installation (40 pages), Instructions d'utilisation et d'installation (40 pages)

Imprimer la page
Miele DA 3160 Instructions d'utilisation et d'installation
Positioning the appliance in
the wall housing unit
To position the appliance correctly,
cut the spacer strip to required depth
T, and then attach it to the back of
the appliance.
T= Depth of carcase K minus depth of
appliance G
^ The depth of appliance G depends
on the lightshield being used:
–
Lightshield to match existing
kitchen furniture
–
DFB lightshield (optional
accesssory)
–
No lightshield.
This is based on a lightshield which
aligns with the front edge of the
carcase.
If the lightshield is further forward or
back, measurement T will need to be
adjusted accordingly.
When installing an interim shelf or
partition wall, the building-in space at
the back must not be less than
180 mm.
If it is less than 180 mm, position the
appliance further back, and reduce
measurement T accordingly. The
building-in position can be rectified
later by adjusting the depth.
^ Cut the spacer strip supplied to
measurement T.
Score along the groove for the
smaller measurement as shown, and
remove the surplus.
^ Screw the spacer strip to the bottom
of the sides of the housing, flush with
the rear wall.
^ Draw a vertical line up both inside
walls of the housing from the front of
the spacer strip.
Installation
25