Burk Plus-X Dual IP-8 Manuel d'installation et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Burk Plus-X Dual IP-8. Burk Plus-X Dual IP-8 11 pages.

Imprimer la page

Introduction

The Plus-X Dual IP-8 Adapter connects directly to existing ARC-16 IP-8 Interface Panels to allow a fast,

easy upgrade from the ARC-16 to the ARC Plus Remote Control. The Plus-X Dual IP-8 Adapter

communicates with the ARC Plus via LAN/WAN, allowing installation anywhere a network connection is

available.

The Plus-X Dual IP-8 Adapter is part of the Plus-X family of Ethernet I/O products designed for the ARC

Plus.

Installation Note

Even though you may operate the ARC Plus and Plus-X Dual IP-8 Adapter on different subnets, Burk

Technology strongly recommends installing the Plus-X Dual IP-8 Adapter on the same LAN as the ARC

Plus. In a network failure, an ARC Plus can only continue to monitor and control a Plus-X device on the

same LAN. If the network link between the units is not available, ARC Plus macros, alarm monitoring

and telephone control will be unavailable for the Plus-X device.

Before you Begin

Before installing the Plus-X Dual IP-8 Adapter, please have the following network settings ready:



A static IP address for the Plus-X Dual IP-8 Adapter



The IP address of your ARC Plus



The subnet mask and gateway address for your LAN

If you will be importing your ARC-16 settings, be sure to save your settings in AutoLoad 2 for the ARC-

16 (this will create a .a16 file). If you will be manually configuring your channels, make careful note of

the following for each channel:



Meter label



Calibration type



Decimal places



High limit



Low limit



Alarm delays (meter and status)



ESI meter label



ESI meter units label



ESI status message



Status inversion setting



Status alarm setting



Command duration

Plus-X Dual IP-8 Adapter Installation and Operation Manual Rev. B