Allo.com 2aCP8eL series Manuel d'installation rapide - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} Allo.com 2aCP8eL series. Allo.com 2aCP8eL series 20 pages. E1/t1 8 port pri card

Imprimer la page

8 Port PRI Card- Quick Installation Guide

5. Software Configurations

Add the line "allo4xxp" at the end in /etc/Dahdi/modules file. The "start dahdi" is to "stop and

start dahdi service" according to deployment scenario.

After compiling and installing DAHDI and Asterisk, load the Dahdi driver by running:

# /etc/init.d/dahdi start

# dahdi_genconf –vvvvv

If there is any error, please trace the cause. Until all errors are clear up, you should

execute "dahdi_genconf" again, and then go to the next step.

By running "dahdi_genconf", it will generate /etc/dahdi/system.conf and etc/asterisk/dahdi-

channels.conf automatically. Check whether the generated files information agrees with your

hardware setup, if not, you should modify to your specific requirements.

Do not forget to confirm dahdi-channels.conf is included in chan_dahdi.conf to

configure Dahdi channels with asterisk, if not, run command:

# echo "#include dahdi-channels.conf" >> /etc/asterisk/chan_dahdi.conf

Execute the following command:

# dahdi_cfg –vvvvv

This command is used for reading and loading parameters in the configuration file system.conf

and writing to the hardware.

Start the Asterisk by executing

www.allo.com

Dahdi Channels Configure With asterisk

Version 2.1