Allo.com 2aCP8eL series 빠른 설치 매뉴얼 - 페이지 16

{카테고리_이름} Allo.com 2aCP8eL series에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allo.com 2aCP8eL series 20 페이지. E1/t1 8 port pri card

8 Port PRI Card- Quick Installation Guide

5. Software Configurations

Add the line "allo4xxp" at the end in /etc/Dahdi/modules file. The "start dahdi" is to "stop and

start dahdi service" according to deployment scenario.

After compiling and installing DAHDI and Asterisk, load the Dahdi driver by running:

# /etc/init.d/dahdi start

# dahdi_genconf –vvvvv

If there is any error, please trace the cause. Until all errors are clear up, you should

execute "dahdi_genconf" again, and then go to the next step.

By running "dahdi_genconf", it will generate /etc/dahdi/system.conf and etc/asterisk/dahdi-

channels.conf automatically. Check whether the generated files information agrees with your

hardware setup, if not, you should modify to your specific requirements.

Do not forget to confirm dahdi-channels.conf is included in chan_dahdi.conf to

configure Dahdi channels with asterisk, if not, run command:

# echo "#include dahdi-channels.conf" >> /etc/asterisk/chan_dahdi.conf

Execute the following command:

# dahdi_cfg –vvvvv

This command is used for reading and loading parameters in the configuration file system.conf

and writing to the hardware.

Start the Asterisk by executing

www.allo.com

Dahdi Channels Configure With asterisk

Version 2.1