Miller Auto-Line XMT 350 OS Manuel du propriétaire - Page 23
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller Auto-Line XMT 350 OS. Miller Auto-Line XMT 350 OS 36 pages.
Imprimer la page
5-1. Front Panel Controls
1
Power Switch
.
The fan motor is thermostatically
controlled and only runs when cooling is
needed.
2
Voltmeter
3
Ammeter
4
V/A (Voltage/Amperage) Adjustment
Control
5
Mode Switch
Mode switch setting determines the process.
SECTION 5 − OPERATION
For Air Carbon Arc (CAC-A) cutting and goug-
ing, place switch in Stick position. For best re-
sults, place Arc Control in the maximum posi-
tion.
6
Arc Control
Control adjusts Dig when Stick mode is se-
lected on mode switch. When set towards
minimum, short-circuit amperage at low arc
voltage is the same as normal welding
amperage.
When set towards maximum, short-circuit
amperage is increased at low arc voltage to
2
assist with arc starts as well as reduce stick-
ing while welding.
Select setting best suited for application.
Control adjusts inductance when either
V-Sense Feeder position is selected on the
mode switch. Inductance (0−100%) determ-
ines the "wetness" of the weld puddle. When
set towards maximum, "wetness" (puddle
fluidity) increases.
When the TIG mode is selected, this control
is not functional.
3
5
4
6
1
Ref. 803 727-B / Ref. 244 303-A
OM-244 642 Page 19