Miller I-24 Manuel du propriétaire - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller I-24. Miller I-24 36 pages.

Imprimer la page
Miller I-24 Manuel du propriétaire

4-1. Front Panel Controls

OM-186 895 Page 18
SECTION 4 – OPERATION
1
Optional Voltage/Wire Speed
Meter
1
2
Optional Voltage/Wire Speed
Switch
Use to choose volts or wire feed
2
speed display.
3
Optional Remote Voltage
Control
3
Use to set welding power source
voltage at the wire feeder. Numbers
are for reference only.
4
Wire Speed Control
4
5
Jog/Purge Switch
Use Jog position to momentarily
feed welding wire at speed set on
Wire Speed control without ener-
gizing welding circuit or shielding
gas valve.
Use Purge position to momentarily
energize gas valve to purge air from
gun or adjust gas regulator.
5
6
Trigger Hold Switch
Push up to weld without holding gun
trigger throughout the weld cycle.
To start weld cycle, press and re-
lease gun trigger within three se-
conds after an arc has been struck.
To end weld, press and release gun
trigger.
Power switch is on rear panel (see
6
Section 3-5)
Ref. 188 340-A