Miller XMS 403 Manuel du propriétaire - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Miller XMS 403. Miller XMS 403 44 pages. 400 volts ce arc welding power source

Imprimer la page

4-10. Welding Parameter Setup Menu (Double Pulsed-MIG/L-TIG And Stick)

4-11. Preparing Power Source For MIG (GMAW) Welding Process

To select MIG welding process, proceed as

follows:

Follow safety precautions according to

Section 1.

Prepare unit according to Section 3.

Use the correct interconnecting cable to

connect power source unit to the wire feed-

er (see Wire Feeder manual).

Use a cable with a correct adapter, connect

gun to the MIG gun connector on wire feed-

er (see Wire Feeder manual).

OM-244 243 Page 22

Connect work clamp cable to the WORK

connector.

If using a water-cooled gun, connect input

coolant hose to blue quick connect fitting

and return coolant hose to red quick con-

nect fitting.

Check coolant level after attaching

torch coolant hoses and running cool-

er. Be sure coolant appears in upper

half of indicator. Add coolant if neces-

sary (see Section 3-12).

Press P2 to enter SET UP menu.

SET UP will appear on D1 and D2

momentarily changing to the se-

lected process parameter values.

Setup permits the viewing and

changing of default parameters for

each process mode.

Double Pulsed-MIG (DP) Mode

D1 displays DP.

D2 displays ON/OFF.

E1 changes the mode of D2.

L-TIG/STICK Mode

D1 displays the welding parameter.

D2 displays the parameter value.

E1 changes the welding parameter.

E2 changes the parameter value.

Incorrect settings in any pro-

cess can result in a program

with undesirable weld charac-

teristics. Setup should only be

used by operators familiar with

various welding processes and

parameters.

Ref. 956142645-5-5

Setting Cooler Status (see Section 4-3)

To prevent damage to water-cooled

torch and components, be sure that

coolant is turned on.

If a remote control is desired, connect it to

the Remote Control receptacle on the wire

feeder (see Wire Feeder manual).

Turn unit On.

Allow time for unit to complete its start up

cycle.

Set MIG welding process using P3 push

button.