Miller 1080 Arrow fx 5 Manuel de l'opérateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Miller 1080 Arrow fx 5. Miller 1080 Arrow fx 5 16 pages. Fluid head
Imprimer la page
Operating Instructions
4. Camera Set-up
2.1 Remove the CAMERA PLATE by pulling down the
SAFETY TAB while rotating the QUICK RELEASE KNOB to
the left. The CAMERA PLATE should pop out.
2.2 Refer to the Camera's owners manual for correct
method of attachment to the CAMERA PLATE. Inspect
the CAMERA PLATE and remove the 1⁄4" and 3/8"
screws (for Mini-DV mount) or the 1⁄4" + PIN ADAPTOR
CARRIAGE (ENG mount) as required.
2.3 Attach camera accessories, battery and the QUICK
RELEASE TRIPOD ADAPTER (if required) to the camera.
It is recommended to estimate the camera's Centre of
Gravity (C of G) for the purpose of correctly positioning
the camera on the CAMERA PLATE. The camera's C of G
can be estimated by placing the camera on to a round rod
and then shifting it backwards or forwards until a balance
point – C of G - is achieved. It is recommended to identify
this point on the camera as it will be useful in step 2.6.
2.4 Attach the CAMERA PLATE to the camera or the QUICK
RELEASE TRIPOD ADAPTOR such that the C of G mark
on the camera is approximately 10 – 20 mm behind the
front edge of the CAMERA PLATE then securely tighten
the screws.
2.5 Align the CAMERA PLATE with the SLIDING PLATFORM
and slide it in until the safety mechanism is engaged.
2.6 Release the SLIDING PLATFORM LOCK and slide the
SLIDING PLATFORM such that the camera's C of G is
directly above the centre axis of the Fluid Head (fig. 9)
and tighten the SLIDING PLATFORM LOCK. If this can
not be achieved then reposition the CAMERA PLATE on
the camera or the QUICK RELEASE TRIPOD ADAPTOR –
step 2.4. This will ensure that the system has maximum
stability.
C of G
7
Sliding
platform
Sliding
platform
lock
Fig. 9