Miller 1080 Arrow fx 5 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Miller 1080 Arrow fx 5. Miller 1080 Arrow fx 5 16 stron. Fluid head

Operating Instructions

4. Camera Set-up

2.1 Remove the CAMERA PLATE by pulling down the

SAFETY TAB while rotating the QUICK RELEASE KNOB to

the left. The CAMERA PLATE should pop out.

2.2 Refer to the Camera's owners manual for correct

method of attachment to the CAMERA PLATE. Inspect

the CAMERA PLATE and remove the 1⁄4" and 3/8"

screws (for Mini-DV mount) or the 1⁄4" + PIN ADAPTOR

CARRIAGE (ENG mount) as required.

2.3 Attach camera accessories, battery and the QUICK

RELEASE TRIPOD ADAPTER (if required) to the camera.

It is recommended to estimate the camera's Centre of

Gravity (C of G) for the purpose of correctly positioning

the camera on the CAMERA PLATE. The camera's C of G

can be estimated by placing the camera on to a round rod

and then shifting it backwards or forwards until a balance

point – C of G - is achieved. It is recommended to identify

this point on the camera as it will be useful in step 2.6.

2.4 Attach the CAMERA PLATE to the camera or the QUICK

RELEASE TRIPOD ADAPTOR such that the C of G mark

on the camera is approximately 10 – 20 mm behind the

front edge of the CAMERA PLATE then securely tighten

the screws.

2.5 Align the CAMERA PLATE with the SLIDING PLATFORM

and slide it in until the safety mechanism is engaged.

2.6 Release the SLIDING PLATFORM LOCK and slide the

SLIDING PLATFORM such that the camera's C of G is

directly above the centre axis of the Fluid Head (fig. 9)

and tighten the SLIDING PLATFORM LOCK. If this can

not be achieved then reposition the CAMERA PLATE on

the camera or the QUICK RELEASE TRIPOD ADAPTOR –

step 2.4. This will ensure that the system has maximum

stability.

C of G

Sliding

platform

Sliding

platform

lock

Fig. 9