Aquapeutics Caribbean Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Aquapeutics Caribbean. Aquapeutics Caribbean 17 pages.

① Install the upper rollers (4b) to the sliding glass door (Don't install the lower rollers first), Then hang

it onto the curved upper rail. After that, place the lower rollers in their track push the threaded portion of

the bolt through the hole in the glass door and install as shown in figures 6 and 6.1

Figure 6

Eccentric roller detail: The eccentric assemblies (figure 6.1, the picture above and the drawing below) are used in both

the upper and lower tracks of the sliding doors. The top ones are installed first. To install the eccentric you first

remove the chrome plastic decorative cover). Unthread the nut, remove the washer, insert the grey plastic eccentric

through the glass door and then replace the washer, and snug up the nut. By turning the grey eccentric wheel the white

wheel is raised or lowered. This allows you to adjust the ride height of each side of the sliding glass door. You want

the door to be as plumb as possible. After the correct positions for the top eccentrics have been determined then you can

tighten them as needed. Now the bottom eccentrics may be installed using a similar method only no fine tuning is

necessary. The bottom ones are simply inserted first their lowest position and then twisted 180 degrees to their highest

position to lock them into the track.

Outside of spa

Inside of

spa

Figure 6.1