Aquapeutics Caribbean 설치 매뉴얼 - 페이지 9
{카테고리_이름} Aquapeutics Caribbean에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aquapeutics Caribbean 17 페이지.
페이지 인쇄① Install the upper rollers (4b) to the sliding glass door (Don't install the lower rollers first), Then hang
it onto the curved upper rail. After that, place the lower rollers in their track push the threaded portion of
the bolt through the hole in the glass door and install as shown in figures 6 and 6.1
Figure 6
Eccentric roller detail: The eccentric assemblies (figure 6.1, the picture above and the drawing below) are used in both
the upper and lower tracks of the sliding doors. The top ones are installed first. To install the eccentric you first
remove the chrome plastic decorative cover). Unthread the nut, remove the washer, insert the grey plastic eccentric
through the glass door and then replace the washer, and snug up the nut. By turning the grey eccentric wheel the white
wheel is raised or lowered. This allows you to adjust the ride height of each side of the sliding glass door. You want
the door to be as plumb as possible. After the correct positions for the top eccentrics have been determined then you can
tighten them as needed. Now the bottom eccentrics may be installed using a similar method only no fine tuning is
necessary. The bottom ones are simply inserted first their lowest position and then twisted 180 degrees to their highest
position to lock them into the track.
4b
4a
Outside of spa
C
Inside of
spa
Figure 6.1