AQUAPHOR RO-31 Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} AQUAPHOR RO-31. AQUAPHOR RO-31 12 pages. Drinking water machine
Également pour AQUAPHOR RO-31 : Manuel d'instruction (17 pages)

Imprimer la page

Figure 4

Figure 5

Clean water tip installation with the stand

and the restrictor (fig. 5)

• Drill a 12 mm hole in the sink (counter top).

• Install the rubber gasket (2) on the bottom of the

stand (1).

• Insert the threaded tail of the stand into the

countertop hole.

• Under the countertop, attach the threaded tail of

the plastic and metal lock washer (3, 4) and screw

on the nut (5).

• Insert the free end of the tube into the stand hole (1)

which is going from the clean water tip.

• Under the countertop, put the free end of the

plastic tube into the sleeve (6), and then the

collet. (7) The distance between the end of the

threaded tail (1) to the sleeve (6) should be approx.

600 mm.

Collector block installation

Fix the block to make the distance under the water

purifier with no less than 50 mm of free place. It is

necessary to make a convenient location for the

purifying cartridges and drain tube replacement. Take

care to ensure that the delivery tubes are pulled freely,

without excessive bending.

Conditioning cartridge installation (fig. 6)

• Locate an appropriate place for the conditioning

cartridge.

• Install the bracket at the selected location using the

supplied hardware (fig. 6a)

• Remove the transport plugs from the conditioning

cartridge, located in the JG sockets (fig. 6b).

• Install the conditioning cartridge to the bracket by

pressing on it (fig. 6c).

Self tapping

screw

Figure 6a

Figure 6b

Figure 6c