AQUAPHOR RO-31 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Системи фільтрації води AQUAPHOR RO-31. AQUAPHOR RO-31 12 сторінок. Drinking water machine
Також для AQUAPHOR RO-31: Інструкція з експлуатації (17 сторінок)

AQUAPHOR RO-31 Посібник користувача
Figure 4
1
2
3
4
5
6
7
Figure 5
Clean water tip installation with the stand
and the restrictor (fig. 5)
• Drill a 12 mm hole in the sink (counter top).
• Install the rubber gasket (2) on the bottom of the
stand (1).
• Insert the threaded tail of the stand into the
countertop hole.
• Under the countertop, attach the threaded tail of
the plastic and metal lock washer (3, 4) and screw
on the nut (5).
• Insert the free end of the tube into the stand hole (1)
which is going from the clean water tip.
• Under the countertop, put the free end of the
plastic tube into the sleeve (6), and then the
collet. (7) The distance between the end of the
threaded tail (1) to the sleeve (6) should be approx.
600 mm.
Collector block installation
Fix the block to make the distance under the water
purifier with no less than 50 mm of free place. It is
necessary to make a convenient location for the
purifying cartridges and drain tube replacement. Take
care to ensure that the delivery tubes are pulled freely,
without excessive bending.
Conditioning cartridge installation (fig. 6)
• Locate an appropriate place for the conditioning
cartridge.
• Install the bracket at the selected location using the
supplied hardware (fig. 6a)
• Remove the transport plugs from the conditioning
cartridge, located in the JG sockets (fig. 6b).
• Install the conditioning cartridge to the bracket by
pressing on it (fig. 6c).
Self tapping
screw
Figure 6a
Figure 6b
Figure 6c
5