Diamond BRET/1G-HR Instructions d'utilisation et d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} Diamond BRET/1G-HR. Diamond BRET/1G-HR 3 pages. Gas crepe grill
Imprimer la page
Operation and installation instructions
400 FG Gas Crepe Grill
OPERATION
Machine presentation
The crepe machine supplied is a gas crepe grill ideal by its weight and size, for uses on small
worktops as well as outside.
The 400 mm diameter allows to make crepes and pancakes.
This machine is for professional use and should therefore be used by qualified personnel. It
should be installed in accordance with applicable regulations by a qualified fitter.
Carefully remove the machine from its package. Place it on a flat support.
The sign plate is located at the back o the machine.
Size and capacity
Machine
Diameter
Weight
400 FG
400
Power pressure
Machine
400 FG
Number of plates
16 kg
1
Butane/Propane
Natural gas
28-30/37 mbar
20 mbar
Operation
Lighting
Press the tap button
Rotate the tap to the large flame position
Bring a flame close to the burner
Keep pressing the tap for about 5 seconds
The burner will stay on
You have a double safety :
If one of the branches of the burner is turned off by a draft, the star located in the middle of
the burner will act as a flame diffuser towards the extinguished branches (patented system).
This can also occur when operating at a reduced flow).
A thermocouple will cut off the gas supply if the burner is completely extinguished.
The machine has a factory set reduced flow. In order to avoid any overheating of the crepe
grill, this position should not be used during the plate heating period (10 to 15 minutes).
Maintenance
Clean your machine frequently using a wet sponge.
Do not clean your machine under running water : water infiltration may damage it.
For a better service, we recommend frequent maintenance by a qualified fitter.
Your machine can work with liquid petroleum gas or with natural gas. To change from one
Heat output
gas to the other, a qualified fitter is required.
3600 W
With machines used in Belgium and in Germany, changing from one gas to the other is
done under the manufacturer's responsibility or his local representative.
Installation
Note : The sides of your machine should not be placed near a wall or partition made of
combustible materials, or should be covered with a good heat isolating material.
A 10 cm distance from the partition is adequate.