AquaScape 91016 Instruction et entretien - Page 7

Parcourez en ligne ou téléchargez le pdf Instruction et entretien pour {nom_de_la_catégorie} AquaScape 91016. AquaScape 91016 16 pages. Pond pump

– A centering bushing is required on both ends of the

impeller shaft, one bushing is located inside the pump

and an outer bushing sits in the water chamber cover.

– Slide the first interior bearing washer onto the ceramic

shaft (Ex. 20.

– Place the ceramic impeller shaft into the pump,

checking to be sure the centering bushing sits inside the

pump (Ex. 21).

Ex. 20

Winter Application

The pump can be run during freezing weather if desired, but should be removed if shutting down the pump for the winter.

Disconnect the tubing if using the side discharge fitting and remove the pump and fountain head from the pond. Clean the

pump and cage screens with fresh water and store the pump in a frost-free location.

☎

aquascapeinc.com |

CAN (866) 766-3426 |

– Carefully, slide the impeller back onto the shaft. Use

caution, the impeller assembly is magnetic and will be

forcefully pulled back into the pump (Ex. 22).

– Install second outer bearing washer over the impeller

shaft (Ex. 23).

Ex.19

– The water chamber cover is replaced by lowering the

cover over the impeller shaft so the impeller shaft sits in

the impeller bushing. The cover tabs should fit inside the

matching slots on the pump face (Ex. 24).

– When the water chamber cover is rotated clock-wise

less than a ¼ turn, the pump discharge fitting on the

pump cover is in the vertical position (Ex. 25).

Ex.21

☎

US (866) 877-6637

Ex. 22

Line Up Tab

Ex. 24

Ex.23

Ex.25