Diamond Audio DASTX12 Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Diamond Audio DASTX12. Diamond Audio DASTX12 13 pages. Powered active shallow spare tire subwoofer

Imprimer la page

INSTALLATION

POWER AND INPUT SIGNAL WIRING

Power wiring is very straight forward. Use a high

quality power kit (not supplied or included)

NOTE: DO NOT USE CCA wiring kits EVER!!!!!

Using this type of wire VOIDS your warranty!

1. Connect your 8 guage power wire

DIRECTLY to the battery B+ terminal

with a high quality ring terminal. Make

sure that a fuse holder is approx. 18

inches from the battery and the fuse

should be NO larger than 20 amperes.

2. Make sure to run the power wire thru a

gromment in the ﬁrewall to eliminate any

possiblitity of shorts.

3. Route the Remote Control cable (phone

wire) thru your vehicle to the sparetire

area of you trunk.

4. Connect a remote turn on wire to your

head units remote output using 16

gauge blue wire (not included)

SPECIAL NOTE:

The DASTX12 is equipped with an

automatic turn on circuit if NO

switched 12 volts is available for

turn-on.

Low Level Input Wiring

Low-level (RCA) input wiring is preferred for best audio performance. Most trunk

or hatchback installations will require a 15-20 foot RCA cable, Always use a high

quality cable.

NOTE: Do not connect BOTH the high level and low level inputs from your

receiver to your ampliﬁer at the same time!

SPECIAL NOTE: Always route power and signal seperately

FUSE

GND

+12V

L+

L-

R-

L-

R+

R-

R+

L+

REM

LOW

POWER

INPUTS

AUTO

POWER ON

OFF

REMOTE