Diamond Audio DASTX12 Panduan Pemilik - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Subwoofer Diamond Audio DASTX12. Diamond Audio DASTX12 13 halaman. Powered active shallow spare tire subwoofer
Halaman CetakINSTALLATION
POWER AND INPUT SIGNAL WIRING
Power wiring is very straight forward. Use a high
quality power kit (not supplied or included)
NOTE: DO NOT USE CCA wiring kits EVER!!!!!
Using this type of wire VOIDS your warranty!
1. Connect your 8 guage power wire
DIRECTLY to the battery B+ terminal
with a high quality ring terminal. Make
sure that a fuse holder is approx. 18
inches from the battery and the fuse
should be NO larger than 20 amperes.
2. Make sure to run the power wire thru a
gromment in the firewall to eliminate any
possiblitity of shorts.
3. Route the Remote Control cable (phone
wire) thru your vehicle to the sparetire
area of you trunk.
4. Connect a remote turn on wire to your
head units remote output using 16
gauge blue wire (not included)
SPECIAL NOTE:
The DASTX12 is equipped with an
automatic turn on circuit if NO
switched 12 volts is available for
turn-on.
Low Level Input Wiring
Low-level (RCA) input wiring is preferred for best audio performance. Most trunk
or hatchback installations will require a 15-20 foot RCA cable, Always use a high
quality cable.
NOTE: Do not connect BOTH the high level and low level inputs from your
receiver to your amplifier at the same time!
SPECIAL NOTE: Always route power and signal seperately
FUSE
GND
+12V
L+
L-
R-
L-
R+
R-
R+
L+
REM
HI
LOW
POWER
INPUTS
AUTO
POWER ON
ON
OFF
REMOTE
5