HP ProCurve 1600M Manuel d'installation - Page 25

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HP ProCurve 1600M. HP ProCurve 1600M 36 pages. Redundant power supply
Également pour HP ProCurve 1600M : Fiche technique (12 pages), Lisez-moi d'abord (8 pages), Manuel du réviseur (27 pages), Manuel complémentaire (2 pages), Manuel complémentaire (2 pages), Manuel d'installation (28 pages), Manuel d'installation (28 pages), Manuel d'installation rapide (2 pages), Manuel d'installation rapide (4 pages), Manuel de l'utilisateur (8 pages), Supplément au manuel (28 pages), Lisez-moi d'abord (16 pages), Installation et retrait (2 pages), Manuel d'installation (12 pages), Manuel de planification et de mise en œuvre (40 pages), Instructions de démontage du produit en fin de vie (2 pages), Manuel d'installation (46 pages), Manuel de diagnostic (2 pages), Instructions de démontage (2 pages)

Imprimer la page

Tip

Number

Problem

The network

connection is not

working properly.

Try the following procedures:

• For the indicated port, verify that both ends of the cabling, at the switch and

the connected device, are securely connected.

• Verify the connected device and switch are both powered on and operating

correctly.

• Verify that you have used the correct cable type for the connection. See

"Cables" on page 21 for the correct cable specifications.

– for any of the twisted-pair connections, in the default configuration (Auto),

either a "straight-through" or a "crossover" cable can be used and the

switch will automatically adjust its operation. See the "Automatic Cable

Sensing" description on page 11 for more information.

Note: If the module configuration is changed to one of the fixed

configuration options though (for example, 100-Full Duplex), then the

port operates as MDI-X only and the correct type of cable must be used.

In general, for connecting to an end node (MDI port), use "straight-

through" cable; for connecting to MDI-X ports on hubs or other

switches, use "crossover" cable.

– for fiber-optic connections, verify that the transmit port on the switch is

connected to the receive port on the connected device, and the switch

receive port is connected to the transmit port on the connected device.

• For a 1000 Mbps connection, verify that the network cabling complies with the

IEEE 802.3ab standard. The cable should be installed according to the ANSI/

TIA/EIA-568-A-5 specifications. Cable testing should comply with the stated

limitations for Attenuation, Near-End Crosstalk, Far-End Crosstalk, Equal-Level

Far-End Crosstalk (ELFEXT), Multiple Disturber ELFEXT, and Return Loss.

The cable verification must include all patch cables from any end devices,

including the switch, to any patch panels in the cabling path.

• Verify that the port has not been disabled through a switch configuration

change.

You can use the console interface, or, if you have configured an IP address

on the switch, use the web browser interface, or HP TopTools for Hubs &

Switches network management software to determine the state of the port

and re-enable the port if necessary.

• Verify that the switch port configuration matches the configuration of the

connected device. For example, if the switch port is configured as "Auto", the

port on the connected device also MUST be configured as "Auto". If the

configurations don't match, the results could be a very unreliable connection

or no link at all.

• If the other procedures don't resolve the problem, try using a different port or

a different cable.

Solution

Troubleshooting